User Tools

Site Tools


product:usb2ax:specs

This is an old revision of the document!


USB2AX: Technical Specifications

The hardware of the USB2AX is relatively simple: only 17 components and a 16x20mm PCB.

At its core is an ATMega32u2, an USB-enabled 8bit MCU with 32KB of FLASH, 2.5KB of RAM and 1KB of EEPROM, running at 16MHz.

The USB2AX v3.1 has a double LED (Red/Green), ESD protection on both connectors (USB and serial), breakout pads for RST, GND, HWB and the 4 SPI pins (PB0 to PB3).

To achieve Half-duplex operation on DATA, TX and RX are shorted together and the firmware alternatively turns ON the transmission or reception side of the MCU's UART. This is inspired by the Arbotix.

Schematics


All Eagle files

The protection circuitry for TX and RX comes from the Ruggeduino, and makes it possible to withstand applying 12V to DATA indefinitely, which can easily happen in real life with a shoddy custom cable, or a damage cable.

Bill Of Material

FIXME

Mechanical

Size: 16mm x 36mm x 7mm (without heat-shrink tubing)

3D CAD file (stl)

product/usb2ax/specs.1364787620.txt.gz · Last modified: 2013/04/01 05:40 by xevel